top of page
Kintsugi Ring. Redwood Burl With 22ct Gold Leaf Inlay

Kintsugi Ring. Redwood Burl With 22ct Gold Leaf Inlay

£180.00Price
Description
Introducing our stunning kintsugi ring made from redwood burl and carbon fibre liner with a striking 22ct gold leaf inlay.
 
A beautiful expression of craftsmanship that blends nature and elegance.

Ring in 1st photo is 6mm width with a carbon fibre liner.
Ring widths available; 4mm, 6mm,  8mm, 10mm, 12mm
 
Finish
Ring is finished in a waterproof gloss armour coating.
 
This ring is customisable
Ring can be made with a 9ct gold, sterling silver liner (price will vary)
Ring can be made with no liner.
Wood type can be changed.
Inlay can be changed to fine silver, 22ct rose gold, copper or a crushed gemstone.
Please message me to discuss any other changes you would like to make to your ring.
 
Aftercare
We do not advise these rings to be worn in water for prolonged periods, even if they have a waterproof coating, because over time the water can corrode the coating. If your ring is finished natural, you will need to wax the ring to keep it protected.
Please do not wear your ring when gardening or DIY work.
Please do not wear any metal rings on the fingers next to the wood ring, as this could dent the wood or chip the coating.
 
All rings with the waterproof coating may need maintenance with a re-coat at some point, as it does not last forever.
Please see re-coat service on website.
 
Handmade in England
 
Quantity

  • SIZING INSTRUCTIONS

    Please read these instructions before ordering.

    You can order this ring without following our instructions but we cannot guarantee that the ring will fit properly, if you go by your own sizing method.

    Some sizing methods used by customers can be 1/2 to 1 size different to the ring gauges we use, and why we prefer to use this  method.

    If you are buying this ring based on your own measurement, please select your size from drop down menu.

    ***If you want to make sure you get the correct size, please read the following***

    Please purchase a metal or solid plastic ring gauge set, but please do not use the 'flimsy' plastic belt gauges.

    You may need to order a few ring gauge sets, or a wide ring gauge set, depending on the width of ring you are having made. The plastic ring gauges are roughly 2mm wide, if you buying a ring 3mm to 4mm 1 ring gauge should be sufficient, for a ring width of 5mm-6mm wide, you will need to buy two sets of gauges and put 2 on your finger at the same time, If you are buying an 8mm ring, you will need to buy 3 gauge sets or you can purchase a wide ring gauge set.

    Please try the ring gauge/s on your finger over a few days to get the best reading, once you are comfortable with the size, remove the ring from the set, then post it to us.

    Once you have purchased your ring gauge, please order the ring by selecting width required but for the size, please select 'NOT SURE YET'  then message me for the address where to post your ring gauge too.

bottom of page